Machined from 6061 Aluminum. With 3D printed inlays.
Remove the oem shifter by prying out the push pin on the front of it.
This new shifter is held in place with 3 set screws. Line the bottom set screw up with the hole in the front of the shaft, lightly snug it up. Evenly tighten the two set screws in the side then finish tightening the lower one. Lastly install the plastic inlays. Only tool required is an 1/8” Allen wrench.
Machined from 6061 Aluminum. With 3D printed inlays.
Remove the oem shifter by prying out the push pin on the front of it.
This new shifter is held in place with 3 set screws. Line the bottom set screw up with the hole in the front of the shaft, lightly snug it up. Evenly tighten the two set screws in the side then finish tightening the lower one. Lastly install the plastic inlays. Only tool required is an 1/8” Allen wrench.
